Panasonic S-LINK V User Manual page 122

Specifications
● Specifications
Designation
Model No.
Supply voltage
Current consumption
Address setting
Resolution
Total accuracy
Channel No.
Input range
Input impedance
External synchronization input
Data conversion time
Occupied input No.
Power
Transmission
External synchronization
signal input
Error
Ambient temperature
(Note 3)
Ambient humidity
Noise immunity
Voltage withstandability
Insulation resistance
Vibration resitance
Shock resistance
Mounting
Tightening torque
Material
Cable
Weight
Accessory
Notes: 1) The data of the address excessing I/O control points is invalid.
2) Be sure to set the 'NOT USED' switch to 'OFF.' If the switch is set to 'ON,' this unit doesn't operate properly.
3) If this product is stored in the control panel together with the other units, the temperature may rise above the specified operation tem-
perature due to the heat generated by the other units.
In this case, install a cooling fan, etc. so that the ambient temperature can be in the specified range.
122
24V DC±10% (supplied from the S-LINK V controller or separate power supply)
80mA or less (excluding connecting device)
0 to 511, settable with switch (Note 1, 2)
Within ±0.8% F.S. (at -10 to +55°C ambient temperature)
Selectable with switch
• Current input: 4 to 20mA
• Voltage input: +1 to +5V, 0 to +10V, -10 to +10V
Current input: Approx. 250Ω, Voltage input: Approx. 1MΩ
Photocoupler input
• Input current: 9mA or less
• Operation voltage:
ON voltage 17V or more (between input and +24V)
OFF voltage 4V or less (between input and +24V)
• Input impedance: Approx. 3.3kΩ
Approx. 1ms (excluding the delay of S-LINK V system transmission time)
Green LED (lights up when the power is ON)
Green LED (blinks to indicate the synchronization signal transmission from S-LINK V controller)
Green LED (lights up when external synchronization signal is input)
-10 to +55°C (No dew condensation or icing allowed), Storage: -20 to +70°C
35 to 85% RH, Storage: 35 to 85% RH
Power line: 500Vp, 10ms cycle, 1µs pulse width
Common : 1,000Vp, 10ms cycle, 1µs pulse width (with noise simulator)
1,000V AC for one min. between all terminals connected together and enclosure
20MΩ, or more, with 500V DC megger between all terminals connected together and enclosure
10 to 150Hz frequency, 0.75mm amplitude or maximum acceleration 49m/s² in X, Y and Z directions for
two hours each
2
490m/s acceleration (approx. 50G) in X, Y and Z directions for three times each
Mounted on DIN rail or by tightening screws
Enclosure: ABS, Mounting base: POM
Analogue input unit mounting base: 1pc.
Analogue input unit
SL-VTAD1
1/4,000 (12 bits)
1 channel
16 points
Red LED (lights up when error occurs)
Mounting screw: 0.8N·m or less
2
0.5mm 4-core flat cable, 0.6m long
Approx. 100g