Panasonic S-LINK V User Manual page 97

● Specifications
Type
Model No.
Supply voltage
W h e n i n p u t i s
Current consumption
O N , i n c l u d i n g
current input
Allowable passing current
Address setting
Input
Output
Output operation
Short-circuit protection
Number of I/O points
Transmission
Input
Output
Output holding
Ambient temperature
Ambient humidity
Noise immunity
Voltage withstandability
Insulation resistance
Vibration resistance
Shock resistance
Material
Cable
Weight
Note: If this product is stored in the control panel together with the other units, the temperature may rise above the specified operation tempera-
ture due to the heat generated by the other units. In this case, install a cooling fan, etc. so that the ambient temperature can be in the
specified range.
Input unit
1-channel type 2-channel type
SL-VCH10 SL-VCH20
24V DC±10% (Supplied from S-LINK V controller or separate power supply)
28mA or less
20mA or less
When 2 points of
inputs are ON,
including current
input
Photo-coupler input
• Current input: 9mA or less
• Operation voltage:
ON voltage: 17V or more (between +24V and input)
OFF voltage: 4V or less (between +24V and input)
• Input impedance: Approx. 3.4kΩ
—
—
—
Input: 1 point Input: 2 points
Green LED (blinks when the synchronization signal is sent from the S-LINK V controller)
Green LED (lights up when the input is turned ON)
—
—
-10 to +55°C (No dew condensation or icing allowed) (Note), Storage: -20 to +70°C
Power line: 500Vp, 10ms cycle, 1µs pulse width
Common: 1,000Vp, 10ms cycle, 1µs pulse width (with noise simulator)
1,000V AC for one min. between all terminals connected together and enclosure
20MΩ, or more, with 500V DC megger between all terminals connected together and enclosure
10 to 150Hz frequency, 0.75mm amplitude or maximum acceleration 49m/s² in X, Y and Z directions for two
hours each
2
490m/s acceleration (approx. 50G) in X, Y and Z directions for three times each
S-LINK V side: 0.5mm
I/O device side: 0.5mm
I/O mixed unit
2-channel type
SL-VCH21
24mA or less
W h e n i n p u t i s
O N , i n c l u d i n g
current input.
When output is
ON
Total: 0.5A or less
Using switches, in the range of 0 to 511
NPN open-collector transistor (photo-isolation)
• Maximum sink current: 100mA
• Applied voltage: 30V DC or less (between output and 0V)
• Residual voltage: 1.5V or less (at 100mA sink current)
The output transistor will be turned on if the output signal is sent
from the signal transmission line.
Input: 1point /
Output: 1 point
Orange LED (lights up when the output is turned ON)
35 to 85% RH, Storage: 35 to 85% RH
Enclosure: Polycarbonate
2
4-core flat cable, 0.6m long
2
4-core flat cable, 0.4m long
Approx. 55g
Specifications
Output unit
1-channel type 2-channel type
SL-VCH11 SL-VCH22
20mA or less
16mA or less
When 2 points of
(When output is ON)
outputs are ON.
—
0.4V or less (at 16mA sink current )
—
Output 1 point Output 2 points
—
Incorporated
97