Flowchart For Error Detection - Panasonic S-LINK V User Manual

Flowchart for error detection

Occurrence of error
Output of error output terminal: OFF
(Low → Hi)
The error indicator will light up.
The error number will appear on
the address display.
Error number
1. Error 1 or 2
2. Error 3, 4, or 5
1
Transmission will be stopped.
Eliminate the cause of the error.
5 seconds later, the system will be
automatically reset.
The error is
automatically eliminated.
Yes
Press the ENTER, , and
buttons at the same time. (Note)
The error indicator will light off.
The address display will perform
rotational indication.
Note: Before following the above procedure, be sure to set the mode selection switch to 'RUN.'
If error output is set
2
The error is
automatically eliminated.
No
No
Troubleshooting
Refer to page 166.
Stops the error indicator from blinking.
Erases the error number shown on the address display.
Yes
Output of error output terminal: ON
(Hi → Low)
The error indicator will blink.
Appendix
The error num-
ber is still shown
on the address
display.
171