Panasonic S-LINK V User Manual page 69

Mode setting Operation
Press key.
Press ENTER key.
Press key or
Press ENTER key.
Press key.
Press and hold ENTER key
until the displayed code
flashes (for 3 seconds).
Press key.
Press and hold ENTER key
(for 3 seconds).
Controller setting default values (values set in our factory before delivery:)
Transmission mode
Error 4 output
operation
Displays the code of the decimal / hexadecimal number set-
ting.
Blinks the displayed code of the decimal / hexadecimal num-
ber setting.
key. Selects either the decimal or hexadecimal number display.
Determines the display.
If the hexadecimal number display is selected, the hexa-
decimal number display mode indicator will light up.
Displays the code of the system setting.
Enters the system setting (blinks).
Alternately displays the number of connected PLC I/O con-
nectors and the number of connected nodes (number of con-
nected I/O units).
Displays the code of the default setting mode.
Displays the indicator check pattern, and sets the default val-
ues.
Sets the items to the initial conditions (default values) in the
CONFIG mode.
Clears the addresses of all the units specified in the system setting.
Number of I/O control Error 1 output
points
operation
Error 5 output Decimal / Hexadecimal
operation number display
Description / Function
Error 2 output
operation
Starting
Indication
e.g.)
Decimal num-
ber
display
Hexadecimal
number display
e.g.)
e.g.)
If 2 PLC I/O
connectors are
connected:
If 4 I/O units
are connected:
End
End
Error 3 output
operation
69