Extension Of Main / Branch Line Cable; Extension Of Exclusive 4-Core Flat Cables ·47; Extension Of Cable Excluding Exclusive 4-Core Flat Cables; Extension Of Cable To I/O Device - Panasonic S-LINK V User Manual

Extension of Main / Branch Line Cable

CAUTION
● If you do not use the exclusive 4-core flat cable, be sure to use the 4-core VCTF cable (non-
shielded) having 0.3 to 2.0mm
ferent types to each other, be sure to select cables having the same cross section. If you connect
cables having different cross sections to each other, abnormal communication signals may be out-
put, and abnormal operation of the system may be caused.
● The cables commercially available have different performances.
Before using these cables, be sure to check operation.
Note: The VCTF cord is the vinyl cabtyre cord that conforms to the requirements of JIS C 3306 'Polyvinyl chloride insulated flexible cords.'
Extension of exclusive 4-core flat cables
Hook-up the cables using the SL-J3A hook-up connector for cable extension to extend the cable.
(For a detailed description of the hook-up method, refer to pages 37, 38 and 41 to 43.)

Extension of cable excluding exclusive 4-core flat cables

Use a connector or junction terminal block commercially available to extend the cable.

Extension of cable to I/O device

Use the snap male connector (SL-CP1, SL-CP2, or SL-CP3) and the snap female connector (SL-CJ1 or
SL-CJ2) to extend the cable to the I/O device.
SL-CJ1 or SL-CJ2
SL-CP1
The snap male connector and the snap female connector cannot be connected to each other
NOTE
if they are in a wrong direction. To connect these connectors, be sure to check the terminal
number marked on each connector.
2
conductor cross section. In addition, if you connect cables of dif-
Claw
Lock hole
Terminal number
or SL-CP2
Claw
SL-CJ1 or SL-CJ2
SL-CP3
Basic Procedures
Lock hole
Terminal number
47