Connecting / Setting Procedures - Panasonic SFC-HC Instruction Manual

Connecting / Setting Procedures

2-3 Connecting / Setting Procedures
This section describes the connecting / setting procedures for both this device and SF4C series.
<In case using intermediate connector type to this device>
1. Set the SF4C series, and check that the
SF4C series works properly. For mounting
method of SF4C series, refer to the respec-
tive Instruction Manuals.
SF4C series
To power supply
3. Turn ON the power, and set the function with this device.
After the power of this device turned ON, approx. 10 sec. will be taken for data transmission with
SF4C series. While data transmission, "
[The control output (OSSD 1 / 2) of SF4C series is set to "OFF" while this device has been connected.]
,Q FDVH RI FRQ¿UPLQJ RSHUDWLRQ RI FKDQJHG VHWWLQJ FRQWHQWV RI SF4C series, turn OFF and turn ON of
the power supply of SF4C series once.
REFERENCE
4. Turn OFF the power of emitter and receiver of SF4C series, then remove this device.
5. Connect both SF4C series and the extension cable with connectors and return the device to the
state described in procedure 1.
6. Turn ON the power of emitter and receiver of SF4C series, and check that the SF4C series works
as set at the procedure 3.
Then, inspect the SF4C series.
REFERENCE
7
Extension cable
with connectors
In case control is set as shutting OFF power of SF4C series from the power supplely
when the control output 1 / 2 (OSSD 1 / 2) becomes OFF, supply power from another
power supply.
Do not turns OFF or disconnect wires during setting. in case power is shut OFF during
setting contents, set the contents again after initialization.
:KHQ ³JRRG´ LQ WKH FKHFN UHVXOW DIWHU FKDQJLQJ VHWWLQJ LV GLVSOD\HG WKH VHWWLQJ LV ¿[HG ,Q
case the "good" is not displayed, set the setting contents again.
Refer to "3-1 Functional Descriptions" for the details of the functions, and refer to "3-2
Function Setting (Operation Procedure)" for the setting procedures of the functions
respectively.
Refer to "Chapter 4 Maintenance" of the SF4C series instruction manual for the details of the
inspection of the SF4C series.
© Panasonic Industrial Devices SUNX Co., Ltd. 2013 MJE-SFCHC No.0037-80V
2. Turn OFF the power, and disconnect the ex-
tension cable with connectors connected to
SF4C series, then connect this device be-
tween emitter (or receiver) of SF4C series
and the extension cable with connectors.
SF4C series
Emitter (or receiver)
FU
NC
TI ON
CA NC
EL
" lights up in revolving.
Extension cable
with connectors
To power supply
EN
TE
R
This device