Mil Connector Output Unit - Panasonic S-LINK V User Manual

Specifications

MIL connector output unit

(SL-VTP16C1, SL-VTP16C1-S: 16-channel)
● Part description
No. Designation
MIL connector for output
1
device
2 Address setting switches
Output holding function
3
setting switch
Output indicators
4
(Orange)
Transmission indicator
5
(Green)
118
4 5
3 2
Used for connection of the output machine.
The above figure shows the SL-VTP16C1.
In the SL-VTP16C1-S, the MIL connector is in a different direction compared with that of the
SL-VTP16C1.
For a detailed description, refer to page 120.
Used for setting of address.
Used for setting of the output holding function.
ON: Holds the current output conditions (output holding).
OFF: Will not hold the current output conditions (output OFF).
Each indicator will light up when the output signal of the corresponding channel is turned ON.
This indicator will blink when the synchronization signal is sent from the S-LINK V controller.
20-pin MIL connector
(Header)
[Conforming to MIL-C-83503]
1
mark
(on connector side)
Connector I/O unit
mounting base
Function