Transmission Cable; I/O Cables And Power Supply Cable For I/O Terminal Board "For Mil Connector Type; Expansion Cable For I/O Terminal Unit - Panasonic MEWNET-F Technical Manual

Remote i/o system
Table of Contents

Advertisement

1. CPU units that can use the MEWNET-F system are as follows.
- FP2, FP2SH, FP3 (Ver. 2.0 or later), FP10SH
2. The value of I/O map allocation is the number of occupied I/O points of each unit that is set when
allocating I/O numbers using the editing software. In case of the MEWNET-F system, it can be treated
as a remote I/O map separately from the normal I/O map. (Refer to "10. Remote I/O map".)
Reference: <Chapter 6 Remote I/O Map>
3. When the FP I/O terminal unit is installed, the allocated values of the I/O map vary according to the
combination of expansion units. Please note the followings; Input + Input: 32X, Output + Output: 32Y,
Input + Output or Output + Input: 16X16Y (Common to 8-point unit and 16-point unit)

1.3.2 Transmission Cable

A two-wire cable is used for the transmission cable.
Name
Two-wire cable
Terminal
1.3.3 I/O Cables and Power Supply Cable for I/O Terminal Board "For MIL
Connector Type"
The following I/O cables are applicable for the I/O terminal board {MIL connector type]. A power supply
cable is supplied with the I/O terminal baord [MIL connector type].
Name
I/O cable
(with one-sided
connector)
Power supply cable

1.3.4 Expansion Cable for I/O Terminal Unit

The following cables are used to connect an expansion unit to the standard I/O terminal unit. A 8 cm
long calbe is attached to an expansion unit as a standard accessory.
Name
PL Mark II expansion
cable
1-10
Specifications
2
VCTF 0.75 mm
Crimp terminals (Ring terminal, insulated ring terminal, fork terminal)
Cable length
Specifications
30-pin For input terminal
1 m
34-pin For output terminal
30-pin For input terminal
2 m
34-pin For output terminal
30-pin For input terminal
3 m
34-pin For output terminal
30-pin For input terminal
4 m
34-pin For output terminal
Standard accessory for AFP287445 and
1 m
AFP87446
Cable length
8 cm
28 cm
48 cm
x 2C (JIS) or equivalent
Product No.
Remarks
Standard accessory for AFP87425 and
APL2510
AFP87428
APL2511
APL2515
Model No.
AFB8521
AFB8531
AFB8522
AFB8532
AFB8523
AFB8533
AFB8524
AFB8534
APL9511

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents