Scanning Settings; Manually Setting The Scanning Size - Xerox WorkCentre C226 User Manual

Network Scanner Operation

Manually Setting the Scanning Size

NOTE:
NOTE:
4-34

Scanning Settings

When sending an image, you can adjust the original size, exposure, resolution, and
file format settings as needed.
If you load an original that is not a standard size (such as an inch size), or if you wish
to change the scanning size, touch the [ORIGINAL] key and set the original size man-
ually.
Perform the following steps after loading the document in the DADF or on the docu-
ment glass.
Standard sizes that can be detected are as follows:
A3, B4, A4, A4R, B5, B5R, A5. (11"x17", 8-1/2"x14", 8-1/2"x11", 8-1/2"x11"R, 5-1/2"x8-
1/2")
If a non-standard size original is loaded (including special sizes), the closest standard
size may be displayed, or the original size may not appear at all.
1. Touch the [ORIGINAL] key.
Lower
Resolution
Programmed
File Format
Auto A4
Original
2. Touch the [MANUAL] key.
Original Size
uto Manual
2-Sided
1-Sided
Booklet
Rotate The Image 90 Degrees
If you wish to rotate the original 90° when creating an image file, click the "ROTATE
THE IMAGE 90 DEGREES" checkbox (a checkmark should appear in the box).
The sizes that can be selected are displayed.
O
[AUTO] is no longer highlighted. [MANUAL] is high-
lighted.
2-Sid
Table
Xerox WorkCentre C226 User Guide