Misfeed In The Saddle Stitch Finisher - Xerox WorkCentre C226 User Manual

Misfeed in the Saddle Stitch Finisher

NOTE:
Xerox WorkCentre C226 User Guide
When a misfeed occurs in the Saddle Stitch Finisher, remove the misfed paper follow-
ing the procedure below.
1. Unlatch the Saddle Stitch Finisher and slide it away from the main unit.
The Saddle Stitch Finisher and the machine are connected at the rear. Exercise
caution when pulling them apart.
2. Remove the misfed paper from the main unit.
3. If there was no misfed paper in step 2, pull roller rotating knob B on the punch unit
towards you and rotate it. (Only when an optional punch unit is installed.)
Roller rotating
knob B
4. Open the top cover.
After removing the misfed paper, open and close the
Duplex Bypass/Inverter Unit to reset the jam indicator.
("Misfeed in the transport area, fusing area, and exit
area" step 1 of "Fusing area" on page 1-50 or step 4 on
page 1-51.)
Rotating roller rotating knob B releases the caught
paper.
Saddle Stitch Finisher
1-67