Misfeed In The High Capacity Feeder - Xerox WorkCentre C226 User Manual

Misfeed in the High Capacity Feeder

Xerox WorkCentre C226 User Guide
2. Place the paper in the centre of the paper table.
3. Push the tray firmly all the way into the machine.
When a misfeed occurs in the High Capacity Feeder, remove the misfed paper, follow-
ing the procedure below.
1. While holding the tray release lever, carefully slide the High Capacity Feeder away
from the main unit until it stops.
Release lever
2. Remove any misfed paper from the main unit and the High Capacity Feeder.
Upper right
side cover
If the misfed paper is stuck inside the machine and cannot be removed, open the
side cover and then remove the misfed paper. (See "Misfeed in the transport area,
fusing area, and exit area" on page 1-49.)
The paper stack must not be higher than the indicator
line (up to 3,500 sheets of Xerox standard paper (80 g/
m2 (21 lbs.))
If the paper type was changed, be sure to change the
appropriate settings as explained in "Setting the paper
type (except the Bypass Tray)" (See page 1-33).
The paper table will automatically rise to the paper feed
position.
High Capacity Feeder
1-75