Troubleshooting; When A Transaction Report Is Printed - Xerox WorkCentre C226 User Manual

When a Transaction Report Is Printed

NOTES:
Xerox WorkCentre C226 User Guide

Troubleshooting

This section contains information to help you make efficient use of the fax features of
the machine, including solutions to common problems.
The machine has been set to automatically print a Transaction Report when a trans-
mission is not successful or when the Broadcast transmission function is used. The
Transaction Report informs you of the result of the operation. When the machine prints
a Transaction Report, be sure to check the contents.
The initial settings (factory settings) for printing Transaction Reports are indicated by
shading below. You can use the key operator program to change the settings
(See "Transaction report print select setting" in the "Fax Unit" section of the WorkCen-
tre C226 System Administration Guide).
• Single sending: Print out all report /
report
• Broadcasting: Print out all report
report
• Receiving: Print out all report / Print out error report only /
• Confidential reception:
The Transaction Report shows the date of transmission, the time transmission began,
the other party's name, the duration of the operation, the number of pages, and the
result.
• The list count appears in the "#" column of the Transaction Report and a serial
number appears in the FILE column. (These numbers are not related to the
transaction.)
• If desired, you can have part of the document printed on the transaction report.
This setting is enabled in the key operator programs. (See "Original print on
transaction report" in the "Fax Unit" section of the WorkCentre C226 System
Administration Guide.)
When a Transaction Report Is Printed
Print out error report only
/ Print out error report only / No printed
Print out notice page / Not print out notice page
/ No printed
No printed report
5-95