Network Scanning (Job Template); Configuring The Network Scanning (Job Template) Environment Settings; Enabling Ports And Setting Up Tcp/Ip - Xerox Versant 80 Press System Administration Manual

Hide thumbs Also See for Versant 80 Press:
Table of Contents

Advertisement

b) Click Reboot. The machine reboots and the setting value is reflected.
12. From the press, print a configuration report to confirm all the e-mail settings.

Network Scanning (Job Template)

Configuring the Network Scanning (Job Template) Environment
Settings
Use the following procedures to configure the environment settings for Network Scanning
(Job Template).

Enabling Ports and Setting up TCP/IP

Note
The ports and TCP/IP configuration also can be performed using CentreWare Internet
Services. Refer to
Configure CentreWare Internet Services
1. Login as the Administrator.
2. Press the Machine Status button on the press User Interface (UI).
3. Select the Tools tab on the UI.
4. Select System Settings.
5. Select Connectivity & Network Setup > Port Settings .
6. Select SNMP.
a) Select Change Settings.
b) Select Port Status then select Change Settings.
c) Select Enabled, and then select Save.
d) Select Close until the Port Settings screen is displayed.
e) Repeat the previous sub-steps to enable the Port Status for SMB or FTP Client,
as required.
f) Repeat the previous sub-steps to enable Internet Services > HTTP on the Internet
Services - Port Status screen.
7. Select Close until the main Tools screen displays.
8. If necessary, set the IP Address; choose one of the following:
To set an IP address, refer to
If an IP address is already set, skip this step.
If DHCP or BOOTP is available in your environment, configure the method for
obtaining the address. If an IP address cannot be obtained automatically or
manual configuration is preferred, confirm the settings of an IP address, a subnet
mask, and a gateway address.
9. Select Close repeatedly until the main Tools screen is displayed.
10. Exit the System Administrator Mode.
Xerox
®
Versant
®
80 Press
System Administration Guide
Configure Environment Settings for Scan Services
Settings.
Connectivity & Network
Setup.
11-9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents