Initialize And/Or Store Settings; Restore Factory Defaults - Xerox WorkCentre C226 User Manual

NOTES:
NOTE:
NOTE:
Xerox WorkCentre C226 User Guide
After the [EXECUTE] key is touched and a test patch printed, a message appears ask-
ing you to begin automatic adjustment. Place the test patch on the document glass as
shown below and touch the [EXECUTE] key.
Yellow
Black
Magenta
Cyan
• Correct adjustment will not be possible if you use the test patch that is printed for
"Auto colour calibration" for the copy function or any other document. If you
attempt to use the wrong test patch, you will return to the message screen that
asks you to begin automatic adjustment. Be sure to place only the test patch
printed out above on the document glass.
• Lay approximately five sheets of copy paper that are the same size as the test
patch on top of the set test patch, and gently close the original cover.
When a message appears informing you that auto colour calibration is completed,
touch the [OK] key to end the procedure.
Before using this program, make sure that the registration is correctly adjusted. If the
registration is not correctly adjusted, perform [AUTO ADJUSTMENT] in "Registration
adjustment" in the "Key Operator Programs" section of the WorkCentre C226 System
Administration Guide.

Initialize and/or store settings

You can restore the CONDITION SETTINGS (page 3-44) and the key operator pro-
gram of the PRINTER SETTINGS of (page 3-55) to the factory default settings. You
can also store the current configuration of these settings in memory, and restore a
stored configuration at a later time.

Restore factory defaults

This restores the CONDITION SETTINGS (page 3-44) and the key operator program
of the PRINTER SETTINGS of (page 3-55) to the factory default settings. If you need
a record of the settings prior to restoration of the default settings, print the CUSTOM
SETTINGS list (page 1-37) and the key operator program list (see "Key Operator Pro-
grams" in the WorkCentre C226 System Administration Guide).
This does not affect "Colour adjustments" in the PRINTER SETTINGS.
After this program is set, exit the key operator program, turn off the main switch, and
then turn on the main switch again after at least 3 seconds. The program will be
effective at this time.
Description of Setting Programs
3-59