Programming An F-Code Memory Box - Xerox WorkCentre C226 User Manual

Fax Unit

Programming an F-Code Memory Box

NOTES:
5-82
A box name, sub-address/passcode, and function must be programmed in a memory
box.
• When programming a new memory box, a sub-address that is being used for
another box cannot be used. The passcode, however, can be the same as a
passcode used in another box.
• A passcode can be omitted.
• Up to 50 F-code memory boxes can be programmed. If 50 F-code memory boxes
have already been programmed, a warning message will appear and you will not
be able to program a new box. First delete an unused F-code memory box
(page 5-88) and then program the new box.
1. Press the [CUSTOM SETTINGS] key and then touch the [ADDRESS CONTROL]
key (refer to steps 1 and 2 on page 5-67).
2. Touch the [F-CODE MEMORY BOX] key.
Custom Index
F-Code Memory Box
3. Touch one of the memory box keys ([POLLING MEMORY], [CONFIDENTIAL], or
[RELAY BROADCAST] ) on the store (upper) line.
Custom Settings
F-Code Memory Box
Store Polling Memory
Amend/Delete Polling Memory
([POLLING MEMORY] is touched in the example here.)
The F-code memory box programming screen appears.
4. Touch the [BOX NAME] key.
F-Code Memory Box / Polling Memory
No.001
Box Name
Sub Address
POLLING TIMES
Ok
Relay
Confidential
Broadcast
Relay
Confidential
Broadcast
The "No." that automatically appears is the lowest num-
ber from 001 to 050 that has not yet been programmed.
When the [BOX NAME] key is touched, the letter-entry
screen appears. Enter up to 18 characters for the name.
Refer to page 5-90 for the procedure for entering letters.
Xerox WorkCentre C226 User Guide