Network Settings; I/O Timeout; Ip Address Setting; Enable Tcp/Ip - Xerox WorkCentre C226 User Manual

NOTE:
NOTE:
Xerox WorkCentre C226 User Guide

I/O timeout

This program is used to set the length of time to wait for an I/O to complete a job on
the parallel port or the network port. If the data stream to the port does not transmit
data for a length of time exceeding the timeout, the job will cancel and the next job will
start processing.
The I/O timeout setting is used to set the amount of time after which an I/O timeout will
occur when waiting for print data.
Default setting: 20 seconds
The allowable range of the time is 1 to 999 seconds.

Network settings

These programs are set when this product is used as a network printer.
After you complete the setting for one program, you must exit the key operator pro-
grams, turn off the main switch, wait briefly, and then turn on the main switch again
before any other programs can be set. The program that was set will be effective after
the power is turned on.
For setting and modification of "Network settings", be sure to consult with the network
administrator.

IP address setting

When using this product in a network that uses the TCP/IP protocol, use this program
to set the IP address (IP address, IP subnet mask, and IP gateway) of this product.
The program is set to ENABLE DHCP by factory default setting, which obtains the IP
address setting automatically. When using this product on a TCP/IP network, be sure
to turn on the "Enable TCP/IP" program below.
If DHCP is used, the IP address assigned to the machine may be changed
automatically on occasion. If this happens, printing will not be possible.

Enable TCP/IP

When using this product in a network that uses the TCP/IP protocol, set this program.
Also set the IP address using the program "IP address setting" above.
Default setting: Enable

Enable NetWare

When using this product in a network that uses the NetWare protocol, set this pro-
gram.
Default setting: Enable
Description of Setting Programs
3-57