Creating A Memory Box For F-Code Transmission; F-Code Polling Memory - Xerox WorkCentre C226 User Manual

Fax Unit

Creating a Memory Box for F-Code Transmission

NOTE:

F-Code Polling Memory

2) Check sub-address
and passcode
3) Polling memory
box opens
5-52
Operations that use F-Code memory boxes include F-Code polling memory (page 5-
52), F-Code confidential transmission (page 5-56), and F-Code relay broadcast trans-
mission (page 5-59). To perform these operations, a memory box for each type of
transmission must be created.
Memory boxes are created in the custom settings. Up to 50 boxes can be created.
The information programmed in each memory box varies slightly depending on
the type of operation. Refer to pages 5-81 to 5-88 for the procedures for creating,
editing, and deleting memory boxes.
After you have programmed a memory box, inform the other party of the box's sub-
address and passcode.
If you attempt to create a box when 50 boxes have already been created, a message
will appear and you will not be able to create the box. First delete an unused box (see
"Editing and Deleting a Memory Box" on page 5-88), and then create the new box.
F-code polling memory allows one fax machine to call another fax machine and acti-
vate reception of a document that has been scanned into the other machine's F-code
polling memory box. Calling another machine and activating reception is called F-code
polling, and scanning a document into a memory box for another machine to retrieve
by polling is called F-code polling memory. This function is approximately the same as
normal polling explained on page 5-34; however, it uses an F-code polling memory
box and is always protected by means of the sub-address and passcode.
How F-code polling memory works
Your machine
x
Product Planning
1) F-code polling
(transmission request)
Sub-address and passcode
are transmitted to your machine
4) Automatic transmission
of document data
to other machine
Xerox WorkCentre C226 User Guide
The other machine
Sub-address
Passcode