Moving This Machine - Xerox WorkCentre C226 User Manual

NOTE:

Moving this machine

CAUTION:
Xerox WorkCentre C226 User Guide
4. Be sure to allow the required space around the machine for servicing and proper
ventilation.
80cm
(31-1/2")
A small amount of ozone is produced within the copier during operation. The emission
level is insufficient to cause any health hazard.
The present recommended long term exposure limit for ozone is 0.1 ppm
3
(0.2 mg/m ) calculated as an 8 hr. time-weighted average concentration.
However, since the small amount that is emitted may have an objectionable odor, it is
advisable to place the copier in a ventilated area.
Pull out the four handles as shown below, grasp them firmly, and keep the machine
horizontal while moving it.
Left side
Exit
tray
Handles
Before lifting the machine, fold
up the exit tray and tape it
securely to the machine.
Two people are required to lift and carry this machine.
If the machine has been placed on a stand/1-Tray Unit:
The stand/1-Tray Unit is on casters for moving. Unlock the casters and the adjusters of
the stand/1-Tray Unit and gently move the machine taking care to steady it to prevent
it from toppling.
For locking and unlocking the casters and the adjusters, see page 1-4.
Installation Requirements
30cm
(11-13/16")
60cm
(23-5/8")
60cm
(23-5/8")
Right side
Bypass
tray
Handles
Before lifting the machine, fold
up the Bypass Tray and tape it
securely to the machine.
1-3