Colour Adjustments; Enable Ethertalk; Enable Netbeui; Reset The Nic - Xerox WorkCentre C226 User Manual

Printer Operation
NOTE:
NOTE:
3-58

Enable EtherTalk

When using this product in a network that uses the EtherTalk protocol, set this pro-
gram.
Default setting: Enable

Enable NetBEUI

When using this product in a network that uses the NetBEUI protocol, set this pro-
gram.
Default setting: Enable

Reset the NIC

This program is used to reset all setting items of NIC (Network Interface Card, namely
Print Server Card) of this product to the factory default settings.
If any of the [NETWORK SETTINGS] were changed prior to execution of this program,
you must turn off the main switch after exiting the key operator program, wait briefly,
and then turn on the main switch to make the factory default settings take effect.

Colour adjustments

This program is used to automatically adjust the colour tone of each colour (cyan,
magenta, yellow, and black).

Auto colour calibration

The Auto Colour Calibration program enables automatic colour gradation correction
when the colour is off.
The colour gradation may not be sufficiently corrected after one correction cycle. If so,
execute the program again.
When the [AUTO COLOUR CALIBRATION] key is touched, the following display will
appear.
Key Operator Programs
Auto Colour Calibration
Use 11"X17" Or A3 Paper For This Adjustment.
Press [Execute] To Print The Test Patch.
OK
Execute
Xerox WorkCentre C226 User Guide