Using The Polling Function - Xerox WorkCentre C226 User Manual

Fax Unit

Using the Polling Function

NOTE:
NOTE:
5-36
A document should not be loaded in the machine when the following operation is per-
formed. When used in conjunction with the timer transmission function, only one poll-
ing job can be stored.
If the other machine has a polling security function (see "Restricting polling access
(polling security)" on page 5-42), use the key operator program to program your own
fax number, and ask the operator of the other machine to appropriately program your
fax number in that machine.
1. In fax mode, touch the [SPECIAL MODES] key and then touch the [POLLING] key.
Special Modes Address Review
Polling
Dual Page
Program
Scan
so that it is not highlighted.
2. Touch the [OK] key.
aker Redial
Ok
ber
3. Dial the number of the other fax machine or touch an auto-dial key (one-touch or
group key).
Corpo.Tps
Xerox Group
When performing serial polling, an auto-dial key that includes a sub-address or
passcode (page 5-49) cannot be selected.
If the address directory screen appears, touch the [CON-
DITION SETTINGS] key to display the condition settings
screen.
The [POLLING] key is highlighted and the polling icon
appears.
To cancel polling, touch the [POLLING] key once again
You will return to the initial screen.
If the condition settings screen appears, touch the
[ADDRESS DIRECTORY] key to display the address
Spe
directory screen.
If you are performing serial polling, touch the [NEXT
ADDRESS] key and repeat this step.
Xerox WorkCentre C226 User Guide