Transparency Film With Insert Sheets - Xerox WorkCentre C226 User Manual

Transparency film with insert sheets

Originals (1-sided)
4
3
2
1
Originals (2-sided)
For two-sided originals,
this is only possible when
using a DADF.
Xerox WorkCentre C226 User Guide
About the steps that follow
If a DADF is being used, see pages 2-13 through 2-19. If the document glass is being
used, see pages 2-21 through 2-24.
To cancel the CENTRING function, touch the [CENTRING] key again on the SPECIAL
MODES screen (step1).
When copying onto transparency film, blank insert sheets can be placed between
transparent sheets.
Example: Inserting insert sheets between transparencies
4
3
2
1
Insert sheets
Before performing the following procedure, touch the [More...] key in the Output dis-
play of the main screen of copy mode to display the OUTPUT settings screen (page 2-
18), and then touch the [LEFT TRAY] key* to set the output tray to the left tray*.
* If the optional Saddle Stitch Finisher is installed, touch the [FINISHER TRAY] key to
set the output tray to the finisher tray.
1. Touch the [TRANSPARENCY INSERTS] key on the SPECIAL MODES screen of
the Special Modes tab.
Copy
Transparency
Inserts
2. Touch the [OK] key on the SPECIAL MODES screen.
Return to the main screen of copy mode.
• Insert sheets cannot be copied on in any mode.
• This mode can be selected only in the 1-sided to
1-sided and 2-sided to 1-sided modes.
• A multiple number of copies cannot be selected
in this mode.
• Transparency film must be fed from the Bypass
Tray.
• Insert sheets must be the same size (A4 or A4R
(8-1/2" x 11" or 8-1/2" x 11"R)) as the transpar-
ency film.
• For best results, use Xerox-recommended trans-
parency film.
The [TRANSPARENCY INSERTS] key is highlighted to
indicate that the function is turned on, and the transpar-
ency inserts icon ( , etc.) appears in the upper left of
the screen.
Special Modes
2-45