Manually Setting The Scanning Size - Xerox WorkCentre C226 User Manual

Manually Setting the Scanning Size

Xerox WorkCentre C226 User Guide
If you load an original that is not a standard size (such as a long original or an INCH
size), or if the size is not detected correctly, you must touch the [ORIGINAL] key and
set the original size manually. Perform the following steps after loading the document
in the DADF tray or on the document glass (see the previous page).
1. Touch the [ORIGINAL] key.
Standard
Resolution
Auto A4
Original
2. Touch the [MANUAL] key.
Original Size
Manual
O
2-Sided
ided
Booklet
3. Touch the desired original size key.
Speaker Redial
Original Size Ok
Auto Manual
Ok
A5 A5R B5
B5R A4 A4R
AB Inch
Speaker Redial
Ok
Original Size
Auto Manual
Ok
A5 A5R B5
B5R A4 A4R
AB
Inch
Speaker Redial
Ok
Original Size
Auto Manual
Ok
1 / 1 / 1 / 1 / 1 /
5 X8 5 X8 R 8 X11
2 2 2 2 2
8 X11R 1 / 8 X14 1 / 11X17
2 2
Inch
AB
Manually Setting the Scanning Size
If the address directory screen appears, touch the [CON-
DITION SETTINGS] key to display the condition settings
screen.
The sizes that can be selected are displayed
[AUTO] is no longer highlighted. [MANUAL] and the orig-
inal size key you touched are highlighted.
To select B4 (8x1/2"x14"), A3 (11"x17"), or "LONG
SIZE", touch the key and then touch the appropriate
original size key.
To select an inch size, touch the [INCH] tab.
Touch the appropriate inch original size key. The
selected key is highlighted. To return to the AB original
size palette, touch the [AB] tab.
5-13