Troubleshooting Saddle Stitch Finisher Problems - Xerox WorkCentre C226 User Manual

General Information

Troubleshooting Saddle Stitch Finisher problems

Problem
Stapling position is
not correct (includ-
ing saddle stitch).
The Saddle Stitch
Finisher does not
operate.
Stapling cannot be
performed (includ-
ing saddle stitch).
The punch hole
positions are not
1
correct*
1-70
15. Push the Saddle Stitch Finisher back against the main unit.
Check the list below before calling for service.
Check
Stapling position not set properly?
Are any Saddle Stitch Finisher covers
open?
Message indicating need to remove
paper from the stapler compiler dis-
played?
Message to check the staple unit dis-
played?
Message to add staples displayed?
Different size paper included?
Is the paper badly curled, preventing sta-
pling?
The punch function is not set to the cor-
rect punch positions.
Solution or cause
Check the stapling position setting. (See
pages 1-72 and 1-73.)
Close all covers. (See pages 1-68 and 1-
69.)
Remove all remaining paper from the
stapler compiler referring to step 4 on
page 1-63.
Remove jammed staples. (See page 1-
63.)
Replace the staple cartridge. (See
page 1-61.) Check that a staple cartridge
has been installed. (See page 1-61.)
Stapling cannot be performed onto differ-
ent size paper.
Differences in paper quality and type
may result in bad curling of output paper.
Take the paper out of the tray or Bypass
Tray, turn it around, and reload it so that
the top and bottom edges are reversed.
Check the allowed hole punch positions.
Xerox WorkCentre C226 User Guide