Default Display Settings; The Number Of Direct Address Keys Displayed Setting; Initial Resolution Setting - Xerox WorkCentre C226 User Manual

Network Scanner Operation
NOTE:
4-66

Default display settings

You can select the initial display that appears when you press the [IMAGE SEND] key
to change to scanner mode or when you press the [CLEAR ALL] key in scanner mode.
Normally the initial display is set to the Condition setting screen (page 4-19).
The following three selections are available:
• Condition setting screen
• Address directory (ABC)
• Address directory (Group)
When an address directory (ABC or Group) is selected, the selected index of that
address directory (page 4-22) is set as the initial screen.
When [SWITCH AUTOMATICALLY TO COPY MODE SCREEN] is selected, the dis-
play will automatically switch to the copy mode screen if no action is taken in the scan/
fax mode screen for 20 seconds.

The number of direct address keys displayed setting

The number of one-touch keys displayed in each address directory screen can be
changed from 6 (the normal setting) to 4 or 9.
Touch [4], [6], or [9] to select the desired number.
For the key name that appears in each one-touch key, a maximum of 18 characters
can appear when the number of one-touch keys displayed is set to 4 or 6. A maximum
of 10 characters can appear when the number of one-touch keys displayed is set to 9.

Initial resolution setting

This is used to change the default resolution setting for transmission in network scan-
ner mode. The default resolution is initially set to "LOWER". To change the setting,
touch the desired resolution key.
• [LOWEST]
(B/W: 150 x 150dpi, Colour: 100 x 100dpi)
• [LOWER]
(B/W: 200 x 200dpi, Colour: 150 x 150dpi)
• [STANDARD]
(B/W: 300 x 300dpi, Colour: 200 x 200dpi)
• [HIGHER]
(B/W: 400 x 400dpi, Colour: 300 x 300dpi)
• [HIGHEST]
(B/W: 600 x 600dpi, Colour: 600 x 600dpi)
Xerox WorkCentre C226 User Guide