Siemens SINUMERIK 828D Programming Manual page 92

Spindle motion
6.1 Spindle speed (S), direction of spindle rotation (M3, M4, M5)
Significance
S...
S<n>=...
:
M3
M<n>=3
:
M4
M<n>=4
:
M5
M<n>=5
SETMS(<n>)
SETMS
Note
Up to three S-values can be programmed per NC block, e.g.:
S... S2=... S3=...
Note
SETMS
92
: Spindle speed in rpm for the master spindle
: Spindle speed in rpm for spindle <n>
Note:
The speed specified with
Direction of spindle rotation clockwise for master spindle
: Spindle direction of rotation CW for spindle <n>
Direction of spindle rotation counterclockwise for master spindle
: Spindle direction of rotation CCW for spindle <n>
Spindle stop for master spindle
: Spindle stop for spindle <n>
: Set spindle <n> as master spindle
: If
SETMS
spindle is used instead.
must be in a separate block.
S0=...
is programmed without a spindle name, the configured master
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
applies to the master spindle.
Fundamentals