Siemens SINUMERIK 828D Programming Manual page 185

Example
Program code
N10 G0 X0 Z0
N20 DIAMOF
N30 G1 X30 S2000 M03 F0.7
N40 DIAMON
N50 G1 X70 Z-20
N60 Z-30
N70 DIAM90
N80 G91 X10 Z-20
N90 G90 X10
N100 M30
Further information
Diameter values (DIAMON/DIAM90)
The diameter values apply for the following data:
● Actual value display of the transverse axis in the workpiece coordinate system
● JOG mode: Increments for incremental dimensions and handwheel travel
● Programming of end positions:
● Reading actual values in the workpiece coordinate system for:
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Interpolation parameters
.
AC
If , , are programmed incrementally (
I J K
, , ,
MEAS MEAW $P_EP[X] $AA_IW[X]
Comment
; Approach starting point.
; Diameter programming off.
; X axis = transverse axis, radius programming
active; traverse to radius position X30.
; The diameter programming is active for the
transverse axis.
; Traverse to diameter position X70 and Z-20.
; Diameter programming for absolute dimensions
and radius programming for incremental
dimensions.
; Incremental dimensions active.
; Absolute dimensions active.
; End of program.
, , for / , if these have been programmed absolutely with
I J K G2 G3
), the radius is always calculated.
IC
Geometry settings
8.3 Dimensions
185