Siemens SINUMERIK 828D Programming Manual page 267

Further information
If the run-in and/or run-out path is very short, the acceleration of the thread axis is higher
than the configured value. This causes an acceleration overload on the axis.
Alarm 22280 ("Programmed run-in path too short") is then issued for the thread run-in (with
the appropriate configuration in MD11411 $MN_ENABLE_ALARM_MASK). The alarm is
purely for information and has no effect on part program execution.
MD10710 $MN_PROG_SD_RESET_SAVE_TAB can be used to specify that the value
written by the part program is written to the corresponding setting data during RESET. The
values are, therefore, retained following power off/on.
Note
DITE
in the axis movement.
When a block with the
programmed under
programmed under
The current dimensions setting (inch/metric) is applied to the programmed run-in/run-out
path.
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
acts at the end of the thread as a rounding clearance. This achieves a smooth change
DITS
is written to SD42010 $SC_THREAD_RAMP_DISP[0] and the path
DITS
is written to SD42010 $SC_THREAD_RAMP_DISP[1].
DITE
9.10 Thread cutting with constant lead (G33)
and/or command is loaded to the interpolator, the path
DITE
Motion commands
267