Tool Change Without Tool Management; Tool Change With T Command - Siemens SINUMERIK 828D Programming Manual

Tool change

4.1 Tool change without tool management

4.1 Tool change without tool management
4.1.1

Tool change with T command

Function
There is a direct tool change when the T command is programmed.
Application
For turning machines with circular magazine.
Syntax
Tool selection:
T<number>
T=<number>
T<n>=<number>
Tool deselection:
T0
T0=<number>
Meaning
:
T
<n>
<number>
:
T0
Example
Program code
N10 T1 D1
...
N70 T0
...
58
Command for tool selection including tool change and activation of the tool
offset
: Spindle number as address extension
Note:
The possibility of programming a spindle number as address extension
depends on the configuration of the machine;
→ see machine manufacturer's specifications)
: Number of the tool
Range of values:
Command for deselection of the active tool
Comment
; Loading of tool T1 and activation of the tool offset D1.
; Deselect tool T1.
0 - 32000
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals