Siemens SINUMERIK 828D Programming Manual page 609

RPL, 364
RTLIOF, 204
RTLION, 204
S
S, 91, 107
S1, 91
S2, 91
SCALE, 353, 375
Scale factor, 375
SCC, 101
SD42440, 173
SD42442, 173
SD42465, 348
SD42940, 88
SD42950, 88
SD43240, 127
SD43250, 127
SETMS, 91
SF, 257
Skip levels, 44
Slotting saw, 79
SOFT, 422
SOFTA, 422
Solid angle, 374
SPCOF, 124
SPCON, 124
Special axes, 438
Special characters, 47
Special tools, 79
Spindle
-Direction of rotation, 91
M functions, 399
Main, 438
Mode, position-controlled, 124
Positioning, 125
-speed, 91, 95
Speed limitation, 109
SPOS, 125
SPOSA, 125
SR, 149
SRA, 149
ST, 149
STA, 149
Start point offset
For thread cutting, 258
Starting point, 25, 193
Statement, 37
Stop
At the end of the cycle, 399
Optional, 399
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Programmed, 399
Straight lines
Interpolation, 209
SUPA, 159, 388
S-value
Interpretation, 93
SVC, 95
Synchronized
Axes, 441
System
-dependent availability, 5
SZS, 33
T
T..., 59
T=..., 58
T0, 58, 59
Tapered thread, 264
Tapping
with compensating chuck, 275
Without compensating chuck, 270
Target point, 193
Thread
Chain, 258
Cutting, 257, 277
Direction of rotation, 259
Multiple, 258
Thread cutting, 268
Thread lead, 268
Three-finger rule, 28
TOFF, 86
TOFFL, 86
TOFFR, 86
TOFRAME, 384
TOFRAMEX, 384
TOFRAMEY, 384
TOFRAMEZ, 384
Tool
-change point, 25
Compensation memory, 70
Cutting edge, 81
Group, 72
Length compensation, 68
Radius compensation, 69, 289
-speed, maximum, 96
Tip, 70
Type, 72
Type number, 72
Tool edge
Reference point, 335
Tool Offset
Index
609