Siemens SINUMERIK 828D Programming Manual page 154

Feed control
7.12 Tooth feedrate (G95 FZ)
Syntax
G95 FZ...
Note
In the block,
There is no fixed programmed sequence.
Significance
G95
:
FZ
Note
Switchover between G95 F... and G95 FZ...
Switching over between
delete the non-active feedrate value in each case.
Note
Derive feedrate with FPR
As is the case with the revolutional feedrate,
feedrate of any rotary axis or spindle (see "Feedrate for positioning axes/spindles (FA, FPR,
FPRAON, FPRAOF) (Page 134)").
CAUTION
Tool change/Changing the master spindle
A subsequent tool change or changing the master spindle must be taken into account by
the user by means of corresponding programming, e.g. reprogramming
CAUTION
Technological concerns such as climb milling or conventional milling, front face milling or
peripheral face milling, etc., along with the path geometry (straight line, circle, etc.), are not
taken into account automatically. Therefore, these factors have to be given consideration
when programming the tooth feedrate.
154
and can be programmed together or in isolation.
G95 FZ
: Type of feedrate: Revolutional feedrate in mm/rev or inch/rev (dependent upon
/ )
G700 G710
For see "Feedrate (G93, G94, G95, F, FGROUP, FL, FGREF) (Page 111)"
G95
Tooth feedrate
Activation:
Effective:
Unit:
G95 F...
with
G95
modal
mm/tooth or inch/tooth (dependent upon
(revolutional feedrate) and
can also be used to derive the tooth
FPR
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
/ )
G700 G710
(tooth feedrate) will
G95 FZ...
.
FZ
Fundamentals