Siemens SINUMERIK 828D Programming Manual page 254

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Motion commands

Contour definitions

2. Programming of the end point of the first straight line by specifying the coordinates

● Corner as transition between the straight lines:

● Rounding as transition between the straight lines:

X... Z... RND=...

● Chamfer as transition between the straight lines:

X... Z... CHR=...

Significance

Identifier for angle programming

The specified value (angle) refers to the abscissa of the active working

plane (Z axis with

Identifier for programming a rounding

The specified value corresponds to the radius of the rounding:

Programming Manual, 07/2010, 6FC5398-1BP40-0BA0

Fundamentals

Show Quick Links

Table of Contents