Siemens SINUMERIK 828D Programming Manual page 190

Geometry settings
8.3 Dimensions
Further information
Diameter values (DIAMONA/DIAM90A)
The diameter values apply for the following data:
● Actual value display of the transverse axis in the workpiece coordinate system
● JOG mode: Increments for incremental dimensions and handwheel travel
● Programming of end positions:
● Reading actual values in the workpiece coordinate system for:
Non-modal axis-specific diameter programming (DAC, DIC, RAC, RIC)
The statements
specific diameter programming is relevant:
● Axis position:
● Oscillating:
● Interpolation parameters:
● Contour definition: Straight line with specified angle
● Rapid retraction:
● Movement in tool direction:
● Smooth approach and retraction:
190
Interpolation parameters
.
AC
If , , are programmed incrementally (
I J K
, , ,
MEAS MEAW $P_EP[X] $AA_IW[X]
, ,
DAC DIC RAC
,
X... POS
, ,
OSP1 OSP2
POLF[AX]
to , , G148,
G140 G143 G147
, , for / , if these have been programmed absolutely with
I J K G2 G3
), the radius is always calculated.
IC
, are permissible for any commands for which channel-
RIC
,
POSA
, ,
OSS OSE POSP
, ,
I J K
MOVT
, , ,
G247 G248 G347 G348
, ,
G340 G341
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals