Further information
Setting offset values
On the operator panel or universal interface, enter the following values in the internal control
zero offset table:
● Coordinates for the offset
● Angle for rotated clamping
● Scaling factors (if required)
Zero offset G54 to G57
The call of one of the four commands
from the basic coordinate system to the workpiece coordinate system.
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
8.1 Settable work offset (G54 to G57, G505 to G599, G53, G500, SUPA, G153)
to
in the NC program moves the zero point
G54
G57
Geometry settings
163