Siemens SINUMERIK 828D Programming Manual page 187

Meaning
Modal axis-specific diameter programming
DIAMONA
DIAM90A
DIAMOFA
DIACYCOFA
<axis>
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
: Command for the activation of the independent axis-specific diameter
programming
The effect of
mode ( /
G90
• for G90, AC:
• for G91, IC:
: Command for the activation of the dependent axis-specific diameter
programming
The effect of
• for G90, AC:
• for G91, IC:
: Command for the deactivation of the axis-specific diameter programming
Axis-specific radius programming takes effect when diameter
programming is deactivated. The effect of
programmed dimensions mode:
• for G90, AC:
• for G91, IC:
: Command for the deactivation of axis-specific diameter programming
during cycle processing.
In this way, computations in the cycle can always be made in the radius.
The last G function active in this group remains active for the position
indicator and the basic block indicator.
: Axis identifier of the axis for which the axis-specific diameter
programming is to be activated
Permitted axis identifiers are as follows:
• Geometry/channel axis name
or
• Machine axis name
Range of
values:
is independent of the programmed dimensions
DIAMONA
or / ):
G91 AC IC
Dimensions in the diameter
Dimensions in the diameter
depends on the programmed dimensions mode:
DIAM90A
Dimensions in the diameter
Dimensions in the radius
Dimensions in the radius
Dimensions in the radius
The axis specified must be a known axis in the
channel.
Other conditions:
• The axis must be permitted for the axis-specific
diameter programming via
MD30460 $MA_BASE_FUNCTION_MASK.
• Rotary axes are not permitted to serve as
transverse axes.
Geometry settings
8.3 Dimensions
is independent of the
DIAMOFA
187