Siemens SINUMERIK 828D Programming Manual page 478

Tables
16.1 Instructions
Operation Meaning
G451 Intersection of equidistances
G460 Activation of collision detection for the
3)
approach and retraction block
G461 Insertion of a circle into the TRC block
G462 Insertion of a straight line into the TRC
block
G500 Deactivation of all adjustable frames,
3)
basic frames are active
G505 to G599 5th ... 99th adjustable work offset
G601 Block change on exact stop fine
3)
G602 Block change on exact stop coarse
G603 Block change at IPO block end
G621 Corner deceleration at all corners
G641 Continuous-path mode with smoothing
as per distance criterion (=
programmable rounding clearance)
G642 Continuous-path mode with smoothing
within the defined tolerances
G643 Continuous-path mode with smoothing
within the defined tolerances (block-
internal)
G644 Continuous-path mode with smoothing
with maximum possible dynamic
response
G645 Continuous-path mode with smoothing
and tangential block transitions within
the defined tolerances
G700 Inch dimensions for geometric and
technological specifications (lengths,
feedrate)
478
W Description see
1) 2)
PGsl
m
Compensation at the outside corners (G450, G451,
DISC) (Page 306)
PGsl
m
Approach and retraction with enhanced retraction
strategies (G460, G461, G462) (Page 321)
PGsl
m
Approach and retraction with enhanced retraction
strategies (G460, G461, G462) (Page 321)
PGsl
m
Approach and retraction with enhanced retraction
strategies (G460, G461, G462) (Page 321)
PGsl
m
Settable work offset (G54 to G57, G505 to G599, G53,
G500, SUPA, G153) (Page 159)
PGsl
m
Settable work offset (G54 to G57, G505 to G599, G53,
G500, SUPA, G153) (Page 159)
PGsl
m
Exact stop (G60, G9, G601, G602, G603) (Page 337)
PGsl
m
Exact stop (G60, G9, G601, G602, G603) (Page 337)
PGsl
m
Exact stop (G60, G9, G601, G602, G603) (Page 337)
PGAsl
m
m PGsl
Continuous-path mode (G64, G641, G642, G643,
G644, G645, ADIS, ADISPOS) (Page 341)
PGsl
m
Continuous-path mode (G64, G641, G642, G643,
G644, G645, ADIS, ADISPOS) (Page 341)
PGsl
m
Continuous-path mode (G64, G641, G642, G643,
G644, G645, ADIS, ADISPOS) (Page 341)
PGsl
m
Continuous-path mode (G64, G641, G642, G643,
G644, G645, ADIS, ADISPOS) (Page 341)
PGsl
m
Continuous-path mode (G64, G641, G642, G643,
G644, G645, ADIS, ADISPOS) (Page 341)
PGsl
m
Inch or metric dimensions (G70/G700, G71/G710)
(Page 180)
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals