Siemens SINUMERIK 828D Programming Manual page 157

Further information
Changing between G93, G94 and G95
can also be programmed when
FZ
deleted when
the same way as with
Reselection of G95
Reselecting
has been programmed).
Non-modal feedrate (FB)
When
feedrate.
SAVE mechanism
In subprograms with the
starting (in the same way as
Multiple feedrate values in one block
The "Multiple feedrate values in one block" function is not possible with tooth feedrate.
Synchronized actions
cannot be programmed from synchronized actions.
FZ
Read tooth feedrate and path feedrate type
The tooth feedrate and the path feedrate type can be read using system variables.
● With preprocessing stop in the part program via system variables:
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
is selected. In other words, when changing between
G95
, the
F FZ
when is already active has no effect (unless a change between
G95 G95
(modal) is active, a non-modal feedrate
G95 FZ...
SAVE
F
$AC_FZ
$AC_F_TYPE
is not active, although it will have no effect and is
G95
value is also deleted.
attribute is written to the value prior to the subprogram
FZ
).
Tooth feedrate effective when the current main run record was
preprocessed.
Path feedrate type effective when the current main run record
was preprocessed.
Value: Significance:
0 mm/min
1 mm/rev
2 inch/min
3 inch/rev
11 mm/tooth
31 inch/tooth
7.12 Tooth feedrate (G95 FZ)
, , and
G93 G94
is interpreted as a tooth
FB...
Feed control
, in
G95
and
F FZ
157