Other Information - Siemens SINUMERIK 828D Programming Manual

Other information

15.1 Axes
Behavior of programmed axis types
Geometry, synchronized and positioning axes are programmed.
● Path axes traverse with feedrate F in accordance with the programmed travel commands.
● Synchronized axes traverse synchronously to path axes and take the same time to
● Positioning axes traverse asynchronously to all other axes. These traversing movements
● Command axes traverse asynchronously to all other axes. These traversing movements
● PLC axes are controlled by the PLC and can traverse asynchronously to all other axes.
436
traverse as all path axes.
take place independently of path and synchronized movements.
take place independently of path and synchronized movements.
The traversing movements take place independently of path and synchronized
movements.
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals