Siemens SINUMERIK 828D Programming Manual page 470

Tables
16.1 Instructions
Operation Meaning
DYNPOS Dynamic response for positioning mode,
tapping
DYNROUGH Dynamic response for roughing
DYNSEMIFIN Dynamic response for finishing
DZERO Marks all D numbers of the TO unit as
invalid
EAUTO Definition of the last spline section by
means of the last 3 points
EGDEF Definition of an electronic gear
EGDEL Delete coupling definition for the
following axis
EGOFC Turn off electronic gear continuously
EGOFS Turn off electronic gear selectively
EGON Turn on electronic gear
EGONSYN Turn on electronic gear
EGONSYNE Turn on electronic gear, with
specification of approach mode
ELSE Program branch, if IF condition not
fulfilled
ENABLE Interrupt ON
ENAT Natural transition to next traversing
3)
block
ENDFOR End line of FOR counter loop
ENDIF End line of IF branch
ENDLABEL End label for part program repetitions
with REPEAT
ENDLOOP End line of endless program loop LOOP
470
W Description see
1) 2)
PGsl
m
Activation of technology-specific dynamic values
(DYNNORM, DYNPOS, DYNROUGH, DYNSEMIFIN,
DYNFINISH) (Page 427)
PGsl
m
Activation of technology-specific dynamic values
(DYNNORM, DYNPOS, DYNROUGH, DYNSEMIFIN,
DYNFINISH) (Page 427)
PGsl
m
Activation of technology-specific dynamic values
(DYNNORM, DYNPOS, DYNROUGH, DYNSEMIFIN,
DYNFINISH) (Page 427)
PGAsl
PGAsl
m
PGAsl
PGAsl
PGAsl
PGAsl
PGAsl
PGAsl
PGAsl
PGAsl
PGAsl
PGAsl
m
PGAsl
PGAsl
PGAsl, FB1(K1)
PGAsl
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals