Siemens SINUMERIK 828D Programming Manual page 376

Coordinate transformations (frames)
12.6 Programmable scale factor (SCALE, ASCALE)
Program code
N10 G17 G54
N20 TRANS X15 Y15
N30 L10
N40 TRANS X40 Y20
N50 AROT RPL=35
N60 ASCALE X0.7 Y0.7
N70 L10
N80G0 X300 Y100 M30
Further information
SCALE X... Y... Z...
You can specify an individual scale factor for each axis, by which the shape is to be reduced
or enlarged. The scale refers to the workpiece coordinate system set with G54 to G57,
G505 to G599.
CAUTION
The
frame.
376
command resets all frame components of the previously activated programmable
SCALE
Comment
; Working plane X/Y, workpiece zero
; Absolute offset
; Machine large pocket
; Absolute offset
; Rotation in the plane through 35°
; Scaling factor for the small pocket
; Machine small pocket
; Retraction, end of program
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
Fundamentals