Siemens SINUMERIK 828D Programming Manual page 188

Geometry settings
8.3 Dimensions
Acceptance of the channel-specific diameter/radius programming
DIAMCHANA
DIAMCHAN
Non-modal axis-specific diameter/radius programming
The non-modal axis-specific diameter/radius programming specifies the dimension type as
a diameter or radius value in the part program and synchronized actions. The modal status
of diameter/radius programming remains unchanged.
DAC
DIC
RAC
RIC
Note
With
displayed as a diameter. This also applies to reading of actual values in the workpiece
coordinate system with
Note
During the replacement of an additional transverse axis because of a
of the diameter/radius programming in the other channel is accepted with
188
: With the
channel status of the diameter/radius programming and is then assigned
to the channel-specific diameter/radius programming.
: With the
diameter programming accept the channel status of the diameter/radius
programming and are then assigned to the channel-specific
diameter/radius programming.
: The
DAC
specified axis:
Diameter in absolute dimensions
: The
DIC
specified axis:
Diameter in incremental dimensions
: The
RAC
specified axis:
Radius in absolute dimensions
: The
RIC
specified axis:
Radius in incremental dimensions
or
DIAMONA[<axis>] DIAM90A[<axis>]
MEAS
command, the specified axis accepts the
DIAMCHANA[<axis>]
command, all axes permitted for the axis-specific
DIAMCHAN
command sets the following dimensions to non-modal for the
command sets the following dimensions to non-modal for the
command sets the following dimensions to non-modal for the
command sets the following dimensions to non-modal for the
, the transverse-axis actual values are always
, , and
MEAW $P_EP[x] $AA_IW[x]
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
.
request, the status
GET
RELEASE[<axis>]
.
Fundamentals