Siemens SINUMERIK 828D Programming Manual page 62

Tool change
4.2 Tool change with tool management (option)
Significance
:
T=
<n>
:
T0
Note
If the selected magazine location is not occupied in a tool magazine, the command acts as
for
empty location.
Example
A circular magazine has locations 1 to 20 with the following tool assignment:
Location
1
2
3
4
5 ... 20
62
Command for tool change and activation of the tool offset
The following specifications are possible:
:
<location>
:
<name>
: Spindle number as address extension
Note:
The possibility of programming a spindle number as address extension
depends on the configuration of the machine; → see machine manufacturer's
specifications)
Command for the tool deselection (magazine location not occupied)
. The selection of the next occupied magazine location can be used to position the
T0
Tool
Drill, duplo no. = 1
Not occupied
Drill, duplo no. = 2
Drill, duplo no. = 3
Not occupied
Number of the magazine location
Name of tool
Note:
The correct notation (upper/lower case) must be observed when
programming a tool name.
Tool group
T15
T10
T1
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
State
Blocked
Enabled
Active
Fundamentals