Siemens SINUMERIK 840D Series Diagnostics Manual page 84

1 Alarms
Remedy:
Program Continuation:
10600
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10601
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10604
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-84
This message is purely informational.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 auxiliary function during thread cutting active
%1 = Channel number
%2 = Block number, label
An auxiliary function output is programmed in a thread cutting block.
- Alarm display.
Consequential errors can occur if the machining path of the thread block is too short and
further blocks (thread blocks) follow in which no machining stop may occur.
Possible remedial measures:
• Program a longer path and/or a lower traversing rate.
• Output auxiliary function in another block (program section).
Clear alarm with the Delete key or NC START.
Channel %1 block %2 zero velocity at block end point during thread cutting
%1 = Channel number
%2 = Block number, label
This alarm occurs only when several blocks with G33 follow in succession. The block end
velocity in the specified block is zero although a further velocity block follows. The rea-
sons for this can be, for instance:
• G9
• Auxiliary function after motion
• Auxiliary function output before the motion of the following block
• Positioning axis in the block
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Please inform the authorized personnel/service department. Modify the NC part program
by removing any programmed "Stop at end of block" G09.
Modify general machine data 11110 AUXFU_GROUP_SPEC [n] for selecting the output
time of an auxiliary function group by changing "Auxiliary function output before/after the
movement" to "Auxiliary function output during the movement".
Bit 5 = 1: Auxiliary function output before movement
Bit 6 = 1: Auxiliary function output during movement
Bit 7 = 1: Auxiliary function output after movement
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 thread lead increase too high
%1 = Channel number
%2 = Block number, label
The thread lead increase is causing an axis overload. A spindle override of 100% is
assumed during verification.
- Alarm display.
- Interface signals are set.
- Local alarm reaction.
- Correction block is reorganized.
Reduce the spindle speed, thread lead increase or path length in the NC program.
Clear alarm with NC START or RESET key and continue the program.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02