Siemens SINUMERIK 840D Series Diagnostics Manual page 393

11.02
61230
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61231
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61232
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61233
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 tool probe diameter too small
%1 = Channel number
%2 = Block number, label
The tool probe is not correctly calibrated.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Calibrate the tool probe.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 ShopMill program %3 cannot be executed, as it has not been
tested by ShopMill
%1 = Channel number
%2 = Block number, label
%3 = Program name
Before a ShopMill program can be executed, it has to be tested by ShopMill. Alarm trig-
gered by following cycles: E_HEAD.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
The program has to be simulated first in ShopMill or loaded into the operating mode
"Machine auto" by ShopMill.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 loading of magazine tool not possible
%1 = Channel number
%2 = Block number, label
Only manual tools may be loaded into a swivel head in which the tools can only be manu-
ally loaded.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Load a manual tool into the swivel head or set the parameter "Tool change" in the start-up
screen form "Rotary axes" to "Automatic".
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Thread inclination incorrectly defined
%1 = Channel number
%2 = Block number, label
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check thread geometry.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-393