Siemens SINUMERIK 840D Series Diagnostics Manual page 409

11.02
62105
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62180
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62181
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62182
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62183
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
62184
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 number of columns or lines is zero
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE801.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2 no name assigned to swivel data block although machine
data $MN_MM_NUM_TOOL_CARRIER > 1
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2 NCK software version unsufficient (missing TOOLCARRIER
functionality)
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2: Load swivel head
%1 = Channel number
%2 = Block number, label
No swivel head is active. Alarm triggered by following cycles: E_TCARR, F_TCARR.
- Alarm display.
Request to load a swivel head.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 retraction mode GUD7 _TC_FR beyond value range 0...2
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
-
Clear alarm with the Delete key or NC START.
Channel %1 block %2 no solution possible with current input angle values
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE800.
- Alarm display.
1 Alarms
1-409