Siemens SINUMERIK 840D Series Diagnostics Manual page 426

1 Alarms
Remedy:
Program Continuation:
101155
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
101156
Definitions:
Reactions:
Remedy:
Program Continuation:
101157
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
101158
Definitions:
Reactions:
Remedy:
Program Continuation:
101159
Definitions:
Reactions:
Remedy:
Program Continuation:
101160
Definitions:
Reactions:
Remedy:
Program Continuation:
101161
Definitions:
1-426
See the Installation and Start-up Guide.
Internal
Path %1 not available
%1 = Path
During a file function, e.g.saving boot files, an attempt was made to access a non-existent
path.
- -
Switch the control OFF/ON or see the Installation and Start-up Guide.
Switch control OFF - ON.
Impermissible function
The selected function is impermissible.
- -
See the Installation and Start-up Guide.
Internal
File %1 not available
%1 = File name
In the start-up area the soft key "delete boot files", for example, was pressed, although no
boot files are yet available.
- -
-
Internal
Function not permitted in the current operating state.
The drive's current status does not permit this function.
- -
-
Internal
Remote block in wrong state
The drive's current status does not permit this function.
- -
-
Internal
Date and time of the PLC set
In the PLC status, the time or date was changed.
- -
-
Internal
The drive is not in cyclic mode!
The start-up is not completely carried out, therefore, the function "Calculate motor data"
cannot be selected.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02