Siemens SINUMERIK 840D Series Diagnostics Manual page 433

11.02
104003
Definitions:
Reactions:
Remedy:
Program Continuation:
104004
Definitions:
Reactions:
Remedy:
Program Continuation:
104005
Definitions:
Reactions:
Remedy:
Program Continuation:
104006
Definitions:
Reactions:
Remedy:
Program Continuation:
104007
Definitions:
Reactions:
Remedy:
Program Continuation:
104008
Definitions:
Reactions:
Remedy:
Program Continuation:
104011
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
There aren't any tools at all
No tools were set up.
- -
Set up tools.
Internal
No tool selected
After pressing the soft key "Current T+D No." in the "Tool overview" window, no tool was
found because no subroutine is active or in the active subroutine no tool is selected.
- -
Select a tool.
Internal
No cutting edge selected
A tool has been selected, but not a cutting edge.
- -
Select a cutting edge.
Internal
No TO area available in the current channel
No TO area is assigned to the current channel.
- -
Assign the current channel a TO area via the machine data, or switch channels.
Internal
Error during tool creation
The tool could not be created, as, for example, the maximum number of possible tools
has already been reached.
- -
Extend the maximum number of tools via the machine data, or delete unnecessary tools.
Internal
Error during cutting edge creation
No new cutting edge could be created, as, for example, the maximum number of cutting
edges has already been reached.
- -
Delete unnecessary cutting edges.
Internal
Error during tool deletion
The tool cannot be deleted. It may currently be active.
- -
-
Internal
1 Alarms
1-433