Siemens SINUMERIK 840D Series Diagnostics Manual page 233

11.02
16785
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16787
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16788
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16789
Parameters:
Definitions:
Reactions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 identical spindles/axes %3
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A coupling has been switched on in which the following spindle/axis is identical to the
master spindle/axis.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department.
• Configure link accordingly in MD (channel MD: COUPLE_AXIS_n)
• or modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 coupling parameter not changeable
%1 = Channel number
%2 = Block number, label
The specified coupling is write-protected. Therefore, the coupling parameters cannot be
modified.
- Alarm display.
- Interface signals are set.
- Interpreter stop
- NC Start disable in this channel.
Please inform the authorized personnel/service department.
• Remove write protection. Channel MD: COUPLE_AXIS_IS_WRITE_PROT
• or modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 cyclic coupling
%1 = Channel number
%2 = Block number, label
A coupling has been switched on which results in a cyclic coupling, allowance being made
for further couplings. This cyclic coupling cannot be uniquely computed.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Please inform the authorized personnel/service department.
• Configure link accordingly in MD (channel MD: 21300 COUPLE_AXIS_n)
• or modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 multiple link
%1 = Channel number
%2 = Block number, label
A coupling has been switched on in which the axes/spindles have already been assigned
by another coupling. Parallel couplings cannot be processed.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
1 Alarms
1-233