Siemens SINUMERIK 840D Series Diagnostics Manual page 174

1 Alarms
Reactions:
Remedy:
Program Continuation:
14122
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14123
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14124
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14125
Parameters:
1-174
Example:
N50 TRAORI (1)
N55 A3=0 B3=0 C3=1
N60 A3=0 B3=0 C3=-1 ; the vector of this block is precisely opposite to that in the preced-
ing block.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify the part program so that the orientation vectors of a block are not directly opposed
to each other, for instance by dividing the block up into 2 subblocks.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 angle and direction of the cone programmed
%1 = Channel number
%2 = Block number, label
With taper circumference interpolation of orientation with ORICONCW and ORICC, only
the opening angle or the direction of the taper may be programmed. Programming of both
in one single block is not allowed.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 nutation angle of the cone too small
%1 = Channel number
%2 = Block number, label
With taper circumference interpolation, the programmed opening angle of the taper must
be greater than the half of the angle between the start and end orientation. Otherwise, a
taper cannot be defined.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 start tangent for orientation is zero
%1 = Channel number
%2 = Block number, label
With taper circumference interpolation with tangential continuation (ORICONTO), the start
tangent of orientation must not be zero.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 programmed rotation is not possible
%1 = Channel number
%2 = Block number, label
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02