Siemens SINUMERIK 840D Series Diagnostics Manual page 203

11.02
14812
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14815
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14820
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14821
Parameters:
Definitions:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Channel %1 block %2 SOFTA not available for axis %3
%1 = Channel number
%2 = Block number, label
%3 = Axis
SOFT is to be set as type of motion control for an axis. This is not possible because a
bent acceleration characteristic has been selected for this axis via machine data.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program or machine data.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 negative thread lead change programmed
%1 = Channel number
%2 = Block number, label
A negative thread lead change has been programmed.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Correct the value assignment. The programmed F value should be greater than zero.
Zero is allowed but has no effect.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 negative value for maximum spindle speed programmed with
constant cutting speed
%1 = Channel number
%2 = Block number, label
For the function "Constant cutting speed G96" a maximum spindle speed can be pro-
grammed with the keyword LIMS=.... The values are in the range 0.1 - 999 999.9 [rev/
min].
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Program the maximum spindle speed for the constant cutting speed within the limits given
above. The keyword LIMS is modal and can either be placed in front of or within the block
that selects the constant cutting speed.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 error in selection or deselection of GWPS
%1 = Channel number
%2 = Block number, label
On selecting grinding wheel surface speed programming with GWPSON, one of the fol-
lowing errors occurred:
• An attempt has been made to select the GWPS programming for a spindle that has
already been assigned to another tool by TMON, GWPSON, CLGON or activation of
the tool length compensation.
• Selection does not refer to a grinding-specific tool (400-499).
• An attempt has been made to select GWPS for the active tool although the TLC is not
switched on.
1 Alarms
1-203