Siemens SINUMERIK 840D Series Diagnostics Manual page 384

1 Alarms
Reactions:
Remedy:
Program Continuation:
61120
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61121
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61122
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61124
Parameters:
Definitions:
Reactions:
1-384
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check thread geometry.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 internal/external thread type not defined
%1 = Channel number
%2 = Block number, label
The thread type (internal/external) was not defined. Alarm triggered by following cycles:
CYCLE70.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
The internal/external thread type must be entered.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 number of teeth per cutting edge missing
%1 = Channel number
%2 = Block number, label
No value was entered for the number of teeth per cutting edge. Alarm triggered by follow-
ing cycles: CYCLE70.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter the number of teeth/cutting edges for the active tool into the tool list.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 safety clearance on the plane incorrectly defined
%1 = Channel number
%2 = Block number, label
The safety clearance is negative or zero. This is not allowed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Define the safety clearance.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 infeed width is not programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE71.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
 Siemens AG, 2002. All rights reserved
11.02